Aqua Lung Calypso Guía para resolver problemas descargar pdf (Pagina 6)

6. Apply a coat of Christo-Lube® to the outside of the

piston head o-ring (3). Insert the piston (4), head rst,

into the cap (2).

7. Apply a coat of Christo-Lube® to the outside of the

shaft o-ring (5). Lower main spring (7) over the shaft of

the piston (4).

8. Apply a light coat of Christo-Lube® to the threads on

the main body (8). Mate the piston cap assembly (2) to

the main body. Thread until hand-tight.

9. Install a new, unlubricated o-ring (9) into the groove

inside the inlet tting (16).

10. Install a new, lubricated o-ring onto the outside of the

inlet tting (16). Using your nger, press t a new coni-

cal lter (14), narrow end rst, into the inlet tting.

11. Load the body (8) into a vise using the vise-mounting

tool. Using a large adjustable wrench, snug the cap (2)

onto the body making sure that metal meets metal.

12. Invert the body (8) in vise. Install the cosmetic black

washer (13), smooth side up, onto the body. Set the

yoke (17 on top of the washer.

13. Thread in the inlet tting (16). Using a ft/lbs torque

wrench, the inlet tting socket (pn 111001) and a 3”

extension, apply a torque of 18 ft/lbs / 24.5 Nm to the

inlet tting. Install dust cap (18) and yoke screw (21).

NOTE: Be careful not to get any lubricant on or near the

conical lter.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Sin comentarios

Aqua Lung Calypso Guía para resolver problemas Pagina 6