Aqua Lung Calypso Guía para resolver problemas descargar pdf (Pagina 5)

Calypso First Stage Service Manual

9. Remove the main spring (7) from the piston cap (2).

Firmly grasp the shaft of the piston (4) and directly pull

it out of the cap.

10. Remove large piston head o-ring (3). Remove piston

shaft o-ring (5).

11. Insert the extraction tool through the head of the piston

(4) and push out the piston HP seat (6).

This Ends Disassembly.

Before starting reassembly, perform parts

cleaning and lubrication in accordance with

Procedure A : Cleaning and Lubricating, (p. 12).

REASSEMBLY PROCEDURES

1. Place a new, lubricated o-ring (11) onto the crown

orice (12). Load the crown orice onto the installation /

extraction tool at end rst.

2. Insert the crown orice (12) into the inlet side (non-

threaded side) of the body (8). Turn the tool over and

press on the head of the crown orice to conrm that it

is seated all the way in the body.

3. Install a new, lubricated o-ring (5) into its groove on the

piston (4) shaft.

4. Install a new, lubricated o-ring (3) onto the head of the

piston (4).

5. Using your nger, press a new HP (6) seat into the end

of the piston (4) until it is seated all the way and is ush

with the end of the piston. If you are unable to press

the HP seat into the piston all the way with your nger,

as an option, you can place the HP seat on a clean

surface and press the piston shaft over it.

1 2 3 4 5 6 7 8 9 10 ... 14 15

Sin comentarios

Aqua Lung Calypso Guía para resolver problemas Pagina 5